Follow these instructions carefully to minimize the risk of expensive water damage. This water line installation is not covered by the refrigerator warranty. Place the handle on the door by fitting the handle footprints over the mounting fasteners and tightening the set screws (2) with a 1/8 in.Allen wrench, and remove the mounting fasteners. Loosen the mounting fasteners (2) with a 1/4 in.Loosen the set screws (1) located on the lower side of the handle with a 1/8 in.Place the handle on the door by fitting the handle footprints over the mounting fasteners and tightening the set screws (2) with a 3/32 in.Assemble the mounting fasteners (1) at both ends of the handle with a 1/4 in.Loosen the mounting fasteners (2) that connect to the refrigerator door and handle using a 1/4 in.Loosen the set screws (1) with a 3/32 in.The appearance of the handles may vary from what is shown.When moving the refrigerator through a narrow opening, removing the doors is preferred.Allow at least 24 inches (610 mm) in front of the refrigerator to open the doors, and at least 2 inches (50.8 mm) between the back of the refrigerator and the wall. Too small of a distance from adjacent items may result in lowered freezing capability and increased electricity consumption charges.The installation location chosen for the refrigerator should allow space behind the unit for connections and airflow and space in front to open the doors and drawers.If an opening is too narrow to fit the refrigerator through, the doors must be removed.Check the dimensions of the appliance and the installation path to ensure there is sufficient room to move the refrigerator through doors or narrow openings. ![]() If the temperature around the appliance is too low or high, cooling ability may be adversely affected.Install this appliance in an area where the temperature is between 55 ☏ (13 ☌) and 110 ☏ (43 ☌).If required, adjust the leveling legs to compensate for the unevenness of the floor. To avoid noise and vibration, the unit must be installed and leveled on a solidly constructed floor.Use an individual, grounded outlet:115 Volts, 60 Hz, AC, 15 Amps minimum.If the refrigerator is installed in an area with low water pressure (below 20 psi or 138 kPa or 1.4 kgf/ cm2 ), you can install a booster pump to compensate for the low pressure. The water pressure must be 20 - 120 psi or 138 - 827 kPa or 1.4 - 8.4 kgf/ cm2.Water supply must be easily connected for the automatic icemaker.Reinstall shelves according to your individual storage needs. Refrigerator shelves are installed in the shipping position. Reinstall or adjust shelves as needed.These products can damage the surface of your refrigerator. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. To remove any remaining tape or glue, rub the area briskly with your thumb.Do not remove any warning labels, the model and serial number label, or the Tech Sheet that is located under the front of the refrigerator. Remove tape and any temporary labels from your refrigerator before using.Please read the following installation instructions first after purchasing this product or transporting it to another location. Provides extra storage within the freezer compartment.Stores food items at a different temperature than the regular refrigerator area.Adjustable shelves to meet individual storage needs.Store frequently used items that require easy access.Sets the refrigerator and freezer temperatures.Produces and stores ice automatically in freezer compartment. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |